COMMUNICATION SETUP
The procedures described below let you set the parame- ters for the Disk Recorder to communicate with external devices.
1.Move the cursor to COMMUNICATION SETUP in the
The COMMUNICATION SETUP menu shown below appears on the monitor screen.
8 COMMUNICATION SETUP
PS•Data SETUP
RS232C SETUP
NETWORK SETUP
IP ADDRESS 
192.168.000.010
NETMASK 
255.255.255.000
GATEWAY 
192.168.000.001
2.Select an item or item parameter in the menu by press- ing the D or C button.
3.To return to the previous setup menu, press the SETUP/ESC button.
●Unit Address Setting
This item lets you set the unit address of the Disk Recorder in the system for
1.Move the cursor to the UNIT ADDRESS parameter by pressing the D or C button.
2.Select the unit address number to be used for
Select a parameter value between 001 and 099.
The factory default setting is 001.
2.Select an item or item parameter in the menu by press- ing the D or C button.
3.To return to the previous
■PS • Data Setup
These items let you set the parameters for communication between the System Controllers and the Disk Recorders when the system is controlled with the PS • Data mode (Panasonic Security Data).
1.Move the cursor to PS • Data SETUP in the COMMUNI- CATION SETUP menu by pressing the C or D button, then press the SET button.
The PS • Data SETUP menu shown below appears on the monitor screen.
UNIT ADDRESS | 001 |
BAUD RATE | 9600 |
DATA BIT | 8 |
PARITY CHECK | NONE |
STOP BIT | 1 |
WAIT TIME | OFF |
ALARM DATA | 1S |
CAMERA NUMBER SETUP
●Baud Rate
This item lets you set the transmission speed for
1.Move the cursor to the BAUD RATE parameter by pressing the D or C button.
2.Select the desired transmission speed shown below by pressing the + or - button.
↔ 2 400 ↔ 4 800 ↔ 9 600 ↔ 19 200 ↔ 38 400 ↔
The factory default setting is 9 600 bps.
●Data Bit
This item lets you set the number of data bits for
The factory default setting is 8 bits and fixed.
68
