■Password Lock Setting
The system setup and operations can be password protect- ed to prevent a malfunction of the system due to accidental erasure of data, alteration of settings or erroneous opera- tions by unauthorized persons.
There are two passwords, defining the operational restric- tions, as shown below.
ALL: Both normal operations and setup operations are allowed.
OPERATION: Only normal operations are allowed.
●Auto Button Locked Setting
This item lets you enable or disable the button lock function automatically.
1.Move the cursor to the AUTO KEY LOCK parameter in the SYSTEM SETUP menu by pressing the C or D but- ton.
2.Select either ON or OFF by pressing the + or - but- ton.
OFF: No protection is applied until the LOCK button is pressed.
ON: Enables the button lock function automatically if no operation takes place within about 5 minutes.
The factory default setting is OFF.
●Password Setting
The items below let you determine the password for the button lock function.
1.Move the cursor to PASSWORD ALL in the SYSTEM SETUP menu by pressing the C or D button, then press the SET button.
The cursor moves to the right editing area.
2.Select a
3.Move the cursor to the right by pressing the B button, then select a digit by pressing the + or - button.
4.Repeat the above steps 2 and 3 until the password is completed.
5.When the password is completed, press the SETUP/ ESC button to return the cursor to ALL.
6.Similarly repeat the above steps 1 to 5 to set the pass- word for OPERATION.
Note: It is recommended to take a note of both pass- words for password verification.
■Buzzer Setting
This item lets you enable or disable the buzzer sound accompanying operation of the Disk Recorder’s buttons.
1.Move the cursor to the BUZZER parameter in the SYS- TEM SETUP menu by pressing the D or C button.
2.Select either ON or OFF by pressing the + or - but- ton.
ON: Enables the buzzer.
OFF: Disables the buzzer.
The factory default setting is ON.
■User Defined Setting
This item lets you select either save or load the user defined setting previously made in the setup menu.
1.Move the cursor to the USER DEFINED SETUP parame- ter in the SYSTEM SETUP menu by pressing the D or C button.
2.Select either mode by pressing the + or - button.
SAVE: Saves the settings currently made as the user defined settings.
LOAD: Restores the settings to the user defined set- tings previously saved.
The factory default setting is LOAD.
3.Press the SET button to display the selected mode setup menu as shown below.
YES NO
[SET]:EXECUTE
YES NO
[SET]:EXECUTE
73
