Panasonic WJ-RT416V manual Connection, Basic connection

Connection

Basic connection

Combination cameras (VIDEO IN 1 - 4) System cameras (VIDEO IN 5 - 16)

Microphones

Amplifier

Video monitor

									Connect the cables from
									the microphone amplifier to
									the AUDIO IN connectors.
HDD	SEQUENCE				SEARCH	STOP	PLAY PAUSE		REC REC STOP
1		1	2	3	4					Connect the video
ERROR					SETUP	COPY
2
ALARM	MULTI	5	6	7	8	REV	FWD	SKIP		monitor to the
4	SCREEN
3
TIMER							–		+
		9	10/0	11	12					monitor 1 connector.
OPERATE	RESET				ESC	SET
5	ALARM
6		13	14	15	16
								Digital Disk Recorder WJ-RT416

External recording device connected to the COPY1 (rear) or COPY2 port (front)

Important:

•When connecting an external recording device, use an optional USB cable to connect it to the COPY1 port on the rear or to the COPY2 port on the front of the recorder.

•Transmission loss of video signals from the cameras connected to the VIDEO IN 1-8 connectors (VIDEO IN 5-8 connectors are available only when an optional board is installed) can be compensated by selecting a proper value for the cable com- pensation setting (Comp.).

S: Suitable when the total cable length between the camera and the recorder is shorter than 500 m

M:Suitable when the total cable length between the camera and the recorder is 500 – 900 m

L:Suitable when the total cable length between the camera and the recorder is 900 – 1 200 m

•Use 5C-2V cable to connect between the recorder and the camera.

•Select a proper value for the cable compensation setting (Comp.) according to the actual length of the cable in use. Otherwise, images from the camera will not be displayed/recorded correctly.

•Audio signal from a microphone should be supplied to the recorder after amplifying to line level (–10 dBv, 51 kΩ) by an amplifier.

42