Panasonic WJ-RT416V manual Configure the RS485 settings RS485 Setup

■Advanced Setup

The following window will be displayed when the [SET] but- ton is pressed after moving the cursor onto "Set→".

Network Setup (Advanced)

DNS		Off
IP Address (Primary)		---.---	.	---.---
IP Address (Secondary)		---.---	.	---.---
Server Port		02000
	OK			Cancel

■DNS

Select "Manual" or "Auto" to enable IP address searching by the host name using the DNS.

Select "Off" when not using the DNS.

Selecting "Auto" is available only when "On" is selected for "DHCP" (using the DHCP server).

When "Manual" is selected for the DNS, enter the DNS serv- er addresses in "IP Address (Primary)" and "IP Address (Secondary)".

Enter 4 units from the decimal numbers (0-255) according to the network configuration.

Default: Off

Server Port

Set the server port number of the recorder (required to use the monitoring software).

1 - 65535 Default: 2000

w Configure the RS485 settings [RS485 Setup]

Configure the RS485 settings.

RS485 Setup

Baud Rate		19200
Data Bit	8
Parity		None
Stop Bit	1
OK		Cancel

■Baud Rate

Select a line speed for data communication with the con- nected device from the following.

2 400/4 800/9 600/19 200/38 400 (bps) Default: 19 200 (bps)

■Data Bit

The data bit will be displayed. It is impossible to change the value.

■Parity

A method of checking for errors in communication function- ing will be displayed. It is impossible to change the value.

■Stop Bit

The stop bit type will be displayed. It is impossible to change the value.

e Configure the PS·Data settings [PS.Data

Setup]

Configure the PS·Data settings.

	PS.Data Setup
Unit Address(System)			001
Unit Address(Controller)			002
Baud Rate			9600
Data Bit			8
Parity			None
Stop Bit			1
Retry Timing			Off
Alarm Data			1s
Camera Number Setup			Set
	OK	Cancel

■ Unit Address (System)

A unit address (Sys) is a unique number assigning to PS·Data devices. The addresses must be unique to identify system devices when connecting multiple devices compatible with PS·Data.

Numbers, "001"-"099", are to be assigned as the unit addresses to the system devices.

Default: 001

■Unit Address (Controller)

A unit address (Ctrl) is a unit address assigning to con- trol PS·Data devices. Numbers, "002"-"099", are to be assigned as the unit addresses to the system controller. Default: 002

64