Paradyne JetFusion Integrated Access Device manual Selecting Fragmentation Types

￿Configuring Maintenance Protocol (page 93)

￿Configuring Congestion Parameters (page 93)

￿Enabling or Disabling Coppermountain CMCP (page 94)

Selecting Fragmentation Types

To select which fragmentation to use:

1.On the Frame Relay Options menu, type 1 to display the FR Fragmentation Configuration menu.

Figure 4–61. Frame Relay Fragmentation Configuration Menu

*****************************************

FR Fragmentation Configuration

*****************************************

1.Configure FRF.12 Fragmentation

2.Configure CopperMountain Fragmentation

2.Do one of the following:

a. Type 1 to select Configure FRF.12 Fragmentation—go to FRF.12 Configuration, following.

—or—

b. Type 2 to select CopperMountain Fragmentation—go to CopperMountain Fragmentation Configuration, on page 92.

Setting FRF.12 Configuration

If you selected FRF.12 Fragmentation, the IAD displays the FRF.12 Configuration menu:

Figure 4–62. FRF.12 Configuration Menu

*****************************************

FR FRF.12 Configuration

*****************************************

1.Enable/Disable FRF.12

2.Enable Automatic Fragment Sizing

3.Set Manual Fragment Size

Type the option and proceed to the corresponding section.

Enabling or Disabling FRF.12

1.Type 1 to enable or disable FRF.12.

The IAD displays the status and a prompt:

FRF.12 Fragmentation is currently DISABLED Enter E to Enable, D to Disable:

Type E to enable End-to-End fragmentation, or type D to disable it.

2.The IAD saves the configuration and displays the FR FRF.12 Configuration menu. Press Escape to continue.

3.Reset the IAD (page 14) when you finish Frame Relay configuration.

2000-A2-GB20-10 - 91 - February 2004