Paradyne JetFusion Integrated Access Device Selecting CPE or CO Mode, Selecting the Line Rate

Selecting CPE or CO Mode

1. Type 2 to display the Configure CPE/CO Mode menu.

Figure 4–11. Configure CPE/CO Mode Menu

*******************************************

Configure CPE/CO Mode

*******************************************

Current Mode: CPE

1.CPE

2.CO

Type 1 to select CPE, or type 2 to select CO mode.

2.The IAD sets the mode and displays the menu.

3.Press Escape to return to the SDSL Configuration Menu.

Enabling and Disabling Adaptive Rate Mode

1. Type 3 to display the G.SHDSL Rate Mode menu.

Figure 4–12. Configure CPE/CO Mode Menu

*******************************************

Configure G.SHDSL Rate Mode

*******************************************

Current Rate Mode: FIXED

1.Fixed

2.Adaptive

Type 1 to select Fixed, or type 2 to select Adaptive.

2.The IAD sets the rate mode and displays the menu.

3.Press Escape to return to the SDSL Configuration Menu.

Selecting the Line Rate

1.Type 4 to display the current line rate and a prompt:

Line Rate is currently: 88 Kbps Enter xDSL Line Rate:

Type a line rate value (between 64 Kbps and 2320 Kbps), which must be a value evenly divisible by 8.

2.The IAD sets the rate and displays the xDSL Configuration Menu.

3.Reset the IAD (page 14) when you finish WAN configuration.

Enabling and Disabling xDSL Debug Messages

NOTE Option D, Enable/Disable G2237 xDSL Debug Messages, is reserved for Paradyne network engineers.

2000-A2-GB20-10 - 58 - February 2004