Paradyne JetFusion Integrated Access Device manual Frame Relay Options, Deleting a Dlci

Configuring

Frame

Relay

Options

16.If you type 2, the IAD displays the fragment size prompt:

Enter maximum fragment size in bytes (100-1600) [0]:

Type the fragment size in bytes and press Enter.

17.The IAD displays the End-to-End Fragmentation Configuration menu. Press Escape to return to the FR DLCI Config menu.

18.Reset the IAD (page 14) when you finish DLCI configuration.

Deleting a DLCI

To delete a DLCI:

1.On the Frame Relay DLCI Configuration menu, type 3 to select Delete DLCI.

2.The IAD displays the port list and prompt:

Port DLCI Encapsulation

1 16 RAW (No Encapsulation) Select Port: [1-8]

Type the port number corresponding to the DLCI you want to delete. a. To permanently remove the DLCI configuration, type y.

b. To cancel the operation, type n.

3.Reset the IAD (page 14) when you finish DLCI configuration.

Displaying Current DLCIs

To display a list of the current DLCIs, type 4 on the Frame Relay DLCI Configuration menu.

The IAD displays the port list:

Port	DLCI	Encapsulation
----	-----	-------------
1	16	RAW (No Encapsulation)

4. Press any key to display the Frame Relay DLCI Configuration menu.

To configure Frame Relay options, type 4 on the WAN Configuration menu. The IAD displays the Frame Relay menu:

Figure 4–60. Frame Relay Options Menu

*****************************************

Frame Relay Options

*****************************************

1.Configure Fragmentation

2.Configure Maintenance Protocol

3.Configure Congestion Parameters

4.Enable/Disable Coppermountain CMCP

To perform these tasks, type the option and proceed to the corresponding section. The tasks in this section are described beginning at the Frame Relay Options menu.

￿Configuring Fragmentation (following)

2000-A2-GB20-10 - 90 - February 2004