Paradyne JetFusion Integrated Access Device manual Using Trace Route, Setting up the USI Port

Using Trace Route

Use Trace Route to trace the network route to a specified host. To run Trace Route, follow these steps:

1.Type X on the Utilities menu and press Enter.

2.Type the IP address or host name to trace and press Enter. If you enter a host name, you must enter the domain name with the host name. For example, mycomputer.mydomain.com.

The IAD displays each hop, as shown in the following sample report:

Trace Route Results to 91.1.1.1

1 5ms 91.1.1.1

Setting up the USI Port

16/24-PortThe USI port is available only on 16/24-port IADs.

To set up the USI port, follow these steps:

1.Type U on the Utilities menu and press Enter.

2.The IAD displays the following:

Enter 1 to enable a USI module as a uart interface on slot 1

Enter 0 to make a USI module a RS530 interface on any slot

->(current=0)

3.Type 1 to select V.35. Type 0 to select RS-530.

4.Reset the IAD (page 14) to use the new USI settings. Voltage levels for V.35 and RS-530 are different. Be sure to use the appropriate cable for the protocol you choose.

Configuring the Console Baud Rate

To set the console port baud rate (for connecting to Hyperterminal via a serial cable), follow these steps:

1. Type Z on the Utilities menu to display the following menu:

Current Console Baud Rate is: 19200

Enter New Console Baud Rate

0.Unset (use Default)

1.9600

2.19200

3.38400

4.57600

5.115200

2.Type 0 to reset the baud rate to the default (19200 bps), or select a specific baud rate and press Enter.

3.Reset the IAD (page 14) to use the new console port settings. Be sure the terminal settings are the same as the console port settings.

Configuring the Console Timeout Period

To maintain security, you can set the amount of time a console or Telnet session remains alive before termination due to inactivity. To set the timeout period, follow these steps:

2000-A2-GB20-10 - 36 - February 2004