Paradyne JetFusion Integrated Access Device manual Router Configuration Menu

Figure 2–2. Router Configuration Menu

*****************************************

Router Configuration Menu

*****************************************

C. Configure Port IP Address U. Unconfigure Port IP Address

M. Configure Port Max Transmission Unit S. Add/Remove a Static Route

R. Enable/Disable RIP

V. Configure RIP Version by Port

P. Configure RIP Poisoned Reverse by Port N. Configure DNS Client

H. Configure DHCP Client

L. Configure DHCP Relay

T. Configure Telnet Server Port F. Configure IP Filtering

Q. Configure IP Header Compression

B. Configure LAN IP Broadcast Destination D. Display Route Table

Type C to select Configure Port IP Address.

3.The IAD displays the following menu (sample—all options shown). The interfaces that display depend on the specific IAD:

Figure 2–3. Router Configuration Menu

Available Interfaces:

1. G2237 xDSL

1.G7070 ADSL ATU-R

1.T1/E1

1.SDSL

2.10/100BaseT Ethernet

0.(Abort)

Type 2 to set the IP address for the Ethernet port.

4.If the IP address is configured for the port, the IAD displays information about the interface and a prompt:

IP interfaces on port 2:

ID	IPAddr	IPMask	Priority
0	92.1.1.90	255.255.255.0	NORMAL

Enter connection to configure:

Type the ID number of the connection that you want to configure (in this case, 0) and press Enter.

5.Type the new IP address, and press Enter (or press Enter to retain the current IP address).

6.The IAD displays the following information:

Current subnet mask = 0.0.0.0

Enter new subnet mask for this interface:

2000-A2-GB20-10 - 13 - February 2004