Paradyne JetFusion Integrated Access Device manual Probable Cause Corrective Action

Table 14–1.Troubleshooting—Symptoms and Causes

Symptom

Cannot receive or send data

If IAD is configured as router:

If the IAD is configured as a bridge:

Probable Cause	Corrective Action
Incorrect PVC/DLCI	Verify these settings:
set for data channel	VPI: 0 to 255
	VCI: 0 to 65535
	DLCI: 16 to 1023
	(default PVC 0/38; DLCI
	32)
	View Interface
	(page 193) and Media
	statistics (page 205) to
	check the pack receive
	and send status.
Incorrect network	Check and correct
setup	network setup as
	necessary.
Incorrect or missing	Ensure that both the LAN
LAN or WAN IP	and WAN IP addresses
address	are configured.
Incorrect or missing	Review the routing table
default static route	and correct as necessary
	(page 217).
Incompatible RIPv1	Check and correct subnet
	masks (255.255.255.0)
	Update RIPv1 to RIPv2.
incorrect bridging	Review IAD configuration
parameters	(page 182) and current
	bridge status (page 218).
	Correct as necessary
Incorrect	Ensure that the IAD is
connection	connected to another
	bridge
Missing peer or	Install a converter to
converter	convert 1483 cells to
	Ethernet packets.

2000-A2-GB20-10 - 245 - February 2004