Schneider Electric AP9635 manual Configure or reconfigure the TCP/IP settings locally

Configure or reconfigure the TCP/IP settings locally

1.Contact your network administrator to obtain valid TCP/IP settings.

2.Connect the provided serial configuration cable (part number 940-0299) from an available communications port on your computer to the serial port of the card or device. Make sure no other application is using the computer port.

3.From the Start menu, launch the Wizard application.

4.If the Network Management Card or network-enabled device is not configured, wait for the Wizard to detect it. Otherwise, click Next>.

5.Select Locally (through the serial port), and click Next >.

6.Enter the system IP, subnet mask, and default gateway for the Management Card or device, and click Next >.

7.On the Transmit Current Settings Remotely screen, if you select Start a Web browser when finished, the default Web browser connects to the Management Card or device after the Wizard transmits the settings.

8.Click Finish to transmit the TCP/IP settings. If the IP address you entered is in use on the network, the Wizard prompts you to enter an IP address that is not in use. Enter a valid IP address, and click Finish.

9.If you selected Start a Web browser when finished in step 7, you can now configure other parameters through the Web interface of the card or device.

Network Management Card User’s Guide 78