Schneider Electric AP9635 manual Output Relay, About

Output Relay Page

This option is only available for devices with installed Dry Contact I/O Accessories. Select the Environment tab, then Universal I/O from the top menu bar. Click Output Relay to display the status of the output relay and configure its values.

Parameter	Description
Name	A name for this output relay. Maximum: 20 characters.
Location	The location of this output relay. Maximum: 20 characters.
Alarm Status	Normal if this output relay is not reporting an alarm, or the severity of the alarm if this
	output relay is reporting an alarm.
State	The current state of this output relay: Closed or Open.
Normal State	The normal (non-alarm) state of this output relay: Closed or Open.
Control	To change the current state of this output relay, check-mark the setting.
Delay	The number of seconds a selected alarm condition must exist before the output relay is
	activated. Use this setting to avoid activating an alarm for brief transient conditions.
	NOTE: Even if additional mapped alarms occur after the delay begins, the delay does not
	restart but continues until the output relay is activated.
Hold	The minimum number of seconds the output relay remains activated after the alarm occurs.
	Even if the activating alarm condition is corrected, the output relay remains activated until
	this time period expires.

About Page

Click About on the left navigation menu of the top menu bar option Environment to display what environmental monitoring devices are in use with this UPS and their firmware versions.

41 UPS Network Management Card 2 User’s Guide