Schneider Electric AP9635 manual Network Management Card User’s Guide

tcpip

[-S [enable disable]] [-i <IP address>] [-s <subnet mask>] [-g <gateway>]

[-d <domain name>] [-h <host name>]

tcpip6

[-S [enable disable]] [-man [enable disable]] [-auto [enable disable]] [-i <IPv6 address>] [-g <IPv6 gateway>]

[-d6 [router stateful stateless never]]

tls [-p]

[-a [enable disable]]

[-m <slave # in hex> <call cause mask in hex>] [-t [primary secondary] <telephone #>]

[-si <# of connected UPS><slaveID1 in hex>...] [-id <slave ID in hex> <id>]

[-d <delay in seconds>]

[-test [appearance disappearance] <bit position>] [-initstr [apc mge <any other string>]] [-dialstr [apc mge <any other string>]] [-resettodef]

uio

[-rc <dI> [open close] [-st <port # port #]] [-disc <port # port #]]

ups

[-input [<phase#> all] [voltage current frequency all]] [-bypass [<phase#> all] [voltage current frequency all]]

[-output [<phase#> all] [voltage current load percload pf frequency all]] [-batt]

[-about] [-al [c w]]

user

[-an <Administrator name>] [-dn <Device User name>] [-rn <Read-Only User name>] [-ap <Administrator password>] [-dp <Device User password>]

[-rp <Read-Only User password>] [-t <inactivity timeout in minutes>]

Network Management Card User’s Guide 92