Paradyne JetFusion Integrated Access Device manual Configur- ing the Sdsl Inter- face- JF2100

Configur- ing the SDSL Inter- face— JF2100

The tasks described in this section all begin on the G2237 xDSL Configuration menu. The tasks are described so you can proceed through them sequentially. You should review and update each of these options as necessary, and reset the IAD when you finish WAN configuration.

To configure the SDSL interface, Type 2 (Configure Physical Interface) on the WAN Configuration menu to display the G2237 xDSL Configuration menu:

JF2104 This section is only for configuring the SDSL WAN interface

JF2104i on the JF2104, JF2104i and JF2108.

JF2108

Figure 4–13. G2237 xDSL Configuration Menu

******************************************

G2237 xDSL Configuration

******************************************

Current Interface Type is: SDSL.

Mode: CPE, Rate Mode: NOKIA AUTO-CYCLE,

Line Rate: 88K, Debug: DISABLED

1.Select xDSL Interface Type

2.Select CPE/CO Mode

3.Enable/Disable Adaptive Rate Mode

4.Select Line Rate

D. Enable/Disable G2237 xDSL Debug Messages

Selecting CPE or CO Mode

1. Type 2 to display the Configure CPE/CO Mode menu.

Figure 4–14. Configure CPE/CO Mode Menu

*******************************************

Configure CPE/CO Mode

*******************************************

Current Mode: CPE

1.CPE

2.CO

Type 1 to select CPE, or type 2 to select CO mode.

2.The IAD sets the mode and displays the menu.

3.Press Escape to return to the SDSL Configuration Menu.

2000-A2-GB20-10 - 59 - February 2004