Paradyne JetFusion Integrated Access Device manual Configur- ing the T1 Interface

Figure 4–23. E1 Configuration Menu

*******************************************

E1 Configuration Menu

*******************************************

1.Select Frame/CRC4 Mode

4.Configure S-Bits

5.Configure Transmit Channels

6.Configure Receive Channels

7.Configure Clock Source

8.Change to T1 Mode

P. Display Physical Layer Stats and Alarm Log

Switching from T1 to E1

If your IAD is set for T1 and it is being deployed in an E1 environment:

1.Type 9 to switch from T1 to E1.

2.The IAD displays this prompt:

T1/E1 mode is currently: T1

Change T1/E1 mode to: E1? (Y = yes):

Type Y to confirm.

3.The IAD resets the interface and saves the configuration. When the interface is reset, the IAD displays the WAN Configuration menu.

Switching from E1 to T1

If your IAD is set for E1 and it is being deployed in an T1 environment:

1.Type 8 to switch from E1 to T1.

2.The IAD displays this prompt:

T1/E1 mode is currently: E1

Change T1/E1 mode to: T1? (Y = yes):

Type Y to confirm.

Configur- ing the T1 Interface

The IAD performs the change, resets the interface, and saves the configuration. When the interface is reset, the IAD displays the WAN Configuration menu.

The tasks described in this section all begin on the T1 Configuration menu. The tasks as described so you can proceed through them sequentially. You should review and update each of these options as necessary, and reset the IAD when you finish WAN configuration.

To configure the T1 interface, Type 2 (Configure Physical Interface) on the WAN Configuration menu to display the T1 Configuration menu:

JF2208 This section is for configuring the T1 interface on the JF2208

JF2216 or JF2216 IAD.

2000-A2-GB20-10 - 66 - February 2004