Paradyne JetFusion Integrated Access Device Inserting, Appending and Editing Filters, Description

Inserting, Appending and Editing Filters

To edit an existing filter, add a new filter in a specific location in the filter table or append a filter to the bottom of the table, follow these steps:

NOTE At any time during the creation or editing of a filter, you can press Escape to abort the process. The IAD displays the IP Filter Configuration menu and the filter table is unchanged.

1.Use the Toggle command (option T) to select input or output filters. Next, choose one of the following and proceed to step 2:

A.To edit an existing filter, type E to select Edit a filter of the chosen type.

B.To insert a new filter, type I to select Insert a new or buffered filter of the chosen type.

C.To append a new filter at the bottom, type A to select Append a new or buffered filter of the chosen type.

2.Follow the IAD messages to enter values for the following parameters:

Table 5–1. Filter Parameters

Parameter

Filter state

Filter action

Filter protocol

Filter Source IP Low Address

Filter Source IP High Address

Filter Source Port Low

Filter Source Port High

Filter Destination IP Low Address

Filter Destination IP High Address

Filter Destination Port Low

Filter Destination Port High

Description

Idle Active

Pass Discard

IP ICMP IGMP TCP UDP

IP address

IP address

Port number

Port number

IP address

IP Address

Port number

Port number

3.When you enter the last parameter, the IAD displays the summary information and saves the configuration. The IAD displays the IP Filter Configuration menu.

4.Continue with other configuration tasks, or press Escape to return to the Router Configuration menu.

5.Reset the IAD (page 14) when you finish IP filter configuration.

2000-A2-GB20-10 - 112 - February 2004