Paradyne JetFusion Integrated Access Device manual Embedded Client, Country Mode Selection Menu

When you select a specific country mode, the values are set automatically:

JF2008 Ring frequency and impedance settings are automatically

JF2104 applied to the JF2008, JF2104 and JF2108.

JF2108

Figure 7–11. Country Mode Selection Menu

*******************************************

Country Mode Selection

*******************************************

Current Country Name is ETSI Generic

Current Country Mode is Europe

A. Australia Complex Impedance

B. ETSI Generic

C. United States of America

1.Type the letter corresponding to the country mode you want to set.

2.The IAD saves the mode you’ve selected and displays the menu.

3.Press Escape to return to the Voice Configuration menu and continue with other voice path configuration.

4.Reset the IAD (page 14) when you finish voice path configuration.

NOTE To add support for any of the countries/regions listed above but not displayed in the Country Mode Selection menu, contact your service provider to obtain the file.

Managing This section applies to MGCP—Voice Over IP—gateway management.

MGCP

Embedded

Client

NOTE The IAD only displays option O, Manage MGCP Embedded Client on the Main menu if you selected Voice Over IP via MGCP 0.1/NCS 1.0 or MGCP 1.0 as the Voice Gateway.

To configure or manage MGCP/NCS, type O to display the MGCP

Management menu:

2000-A2-GB20-10 - 138 - February 2004