Paradyne JetFusion Integrated Access Device manual Editing a Filter in the Buffer

When you’re done viewing the details, press any key to return to the IP Filter Copy to Buffer menu.

Table 5–2. Filter Details

Parameter	Description
num	number of the filter
state	Idle or Active
action	Pass or Discard
srcLwP	Filter Source Port Low—TCP or UDP packets
	only
srcHiP	Filter Source Port High—TCP or UDP packets
	only
source.ip.addr.low	Filter Destination IP Low Address
source.ip.addr.high	Filter Source IP High Address
proto	Filter protocol—IP, ICMP, IGMP, TCP, UDP
mask	ICMP or TCP only
dstLwP	Filter Destination Port Low
dstHiP	Filter Destination Port High
dest.ip.addr.low	Filter Destination IP Low Address
dest.ip.addr.high	Filter Destination IP High Address

Editing a Filter in the Buffer

To edit a filter currently stored in the buffer, follow these steps:

1.On the IP Filter Copy to Buffer menu, type E to edit the filter.

2.Follow the IAD messages to enter values (page 112).

3.When you enter the last parameter, the IAD displays the summary information and saves the configuration. The IAD displays the IP Filter Configuration menu.

4.Continue with other configuration tasks, or press Escape to return to the Router Configuration menu.

5.Reset the IAD (page 14) when you finish IP filter configuration.

Deleting a Filter from the Buffer

To delete a filter currently stored in the buffer, type X.

The IAD deletes the filter from the buffer and displays the IP Filter Configuration menu.

2000-A2-GB20-10 - 114 - February 2004