Paradyne JetFusion Integrated Access Device manual AC Power, Front Panel LEDs

Table 1–2. Front Panel LEDs

LED

POWER LAN LINK

LAN ACT WAN LINK

VOICE

DCE LINK

DCE ACT

Description

Illuminates when the IAD is powered on.

Illuminates when there is an operational LAN connection on the Ethernet port.

Flashes when there is activity on the Ethernet port.

Flashes as the IAD is establishing a link, and illuminates solid when there is a proper connection on the DSL WAN port and synchronization has been achieved.

Illuminates when there is activity on the voice ports. When connected to a Jetstream Voice Gateway, it remains lit, and blinks when there is activity.

Illuminates when there is a link between the IAD and data communications equipment (DCE).

Illuminates or blinks when there is activity on the DCE link.

Rear Panel Connectors

On the rear panel, the IAD contains several connectors. The WAN connectors vary by IAD—both are present, but one has a permanently attached metal shield to prevent use.

Figure 1–5. 16/24-Port IAD Back Panel 12￿￿-
-+￿.￿*￿￿+,,	￿￿￿)*￿*￿￿￿￿￿￿	-&-	0￿*￿￿,￿￿￿3&'￿￿￿4
￿￿/+￿)￿0￿/1￿	￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿		&)	￿+￿-+)	!+0￿)￿0￿)-
			!"5￿￿-￿￿5￿	-￿￿5
￿￿￿ !				￿￿￿￿￿￿￿&'￿(￿￿￿￿	￿￿￿￿￿￿￿￿￿￿￿￿￿￿
￿"￿￿￿" #$%
￿￿0￿￿￿*/￿.￿￿

AC Power

Connects the IAD to an AC outlet of 108-130 volts via an AC power cord.

10/100Base-T Ethernet Port

Connects the IAD to the local area network using a CAT-5 straight through Ethernet cable, or directly to a PC for accessing via Telnet (using a cross- over cable, customer-supplied).

WAN Interfaces

Depending on the IAD, WAN interfaces include the following:

￿T1/E1—uses an RJ48 connector for the connection.

￿SDSL—uses an RJ45 connector for the connection.

2000-A2-GB20-10 - 6 - February 2004