I N S T A L L A T I O N & S E T U P

2

This chapter explains how to install the verifier and connect all the cables. You need a Phillips screwdriver and a 3/32 Hex key (wrench).

Throughout this chapter, the reference to “knife setup” is for the 9860 printer; the reference to “non-knife setup” is for the 9855 printer.

The verifier does not work with a 9855 printer using the Monarch926knife.

I n s t a l l i n g t h e V e r i f i e r

1.Turn off the printer.

2.Place the printer on a firm work surface.

3.Remove the following items from their packaging:

(1)

base plate

(2)

shafts

(1)

stand

(1)

mounting block

(4)

feet

(1)

L-bracket

(1)

¼” plain cork washer

(1)

¼”-20x1¼” screw

(5)M4x12 screws with attached lock washers

(6)#10-32x1/4” set screws

4.Turn the base plate upside down and attach the adhesive feet in each corner. Make sure the base plate looks like the one pictured before you attach the feet. Pay attention to the pattern of the mounting

holes.

Installation & Setup 2-1