Paxar 938 Connecting the Cables

Connecting the Cables

1.Turn off the printer.

2.Connect the I/O cable to the verifier.

3.Connect the communication cable from the verifier to the printer primarily to update the verifier for each bar code on the label.

See “Cable Summary” in Chapter 4 for more information about cable setup.

Communication Cable

I/O Cable

Knife Setup

Non-Knife Setup

4.Lay the cables on top of the base plate (the printer sits on top of them).

Installation & Setup 2-7

Contents

Page Trademarks FCC Notice Caution Statement of FCC Compliance: Canada CE: Use with NRTL-ListedEquipment Cautions: ♦Laser light - Do not stare into the beam Caution: Do not Page USING THE VCT CONFIGURING THE PRINTER TROUBLESHOOTING SPECIFICATIONS A-1 Chapter Contents Getting Started Note: Do not setup.exe .exe Page Page Page Note: Do not fully tighten these screws Note: Securely tighten the set screws with a 3/32 Hex key Page Page Page Connecting the Cables Installing the Printer Make sure the cables underneath the printer are flat and not in the way Securely tighten ALL the set screws Escape/Clear Page Parallel Bar Code Direction Parallel Bar Code Positioning Specifications No-ScanZone Page Note: Report an Analysis Page Page File Use Wizard… ext New… 1.Click the Additional Values tab ~OS0 Add to List Save or Save As Save as MPCL Store Configuration in Printer Send Configuration to Verifier (via Printer) Send Configuration to Verifier (via Direct Connection) Syntax {V,format#,action,device,”name”¦ D,”vfr_comds”¦} Example {V,1,A,T,”BEAMON”¦ D,”~LV02”¦} Syntax V,vfrID¦ Example {F,25,A,R,M,508,508,"Fmt 25"¦ V,3¦ {V,1,A,T,”BEAMON”¦ D,”~LV02”¦} {F,1,A,R,E,200,200,”Fmt1”¦ {F,9,A,R,E,200,200,"Fmt9"¦ V,3¦ R,62¦ do not Page Option Choices Default Verifier Enter/Pause Do not Yes 2.Press Enter/Pause Page Page Do not use the overstrike action with Error Action Standard RFID with Peel Page Supply select Setup, Flash Memory, and Page Power/Sync LED Calibration Read LED Indicator LED Page Supported Bar Codes: