S e t t i n g t h e M o d e

You can select the verifier mode (2 or 19) or use a custom configuration. Use the Verifier Configuration Tool to create a custom verifier configuration.

Mode 2 (Def 2) specifies nine different parameters to verify: ANSI defects, decodability, and grade; quiet zones; partial decodes, decode errors, passing percent decode; minimum number of I2of5 digits; and no read.

Mode 19 (Def 19) specifies all parameters from Mode 2, plus contrast grade, wide to narrow ratio, and minimum and maximum X-dimensions.

Check with your System Administrator on which mode to use.

To change the setting, from the Main Menu, select Setup, then Verifier. Then follow these steps.

1. Press or until you see

VERIFIER

Mode

2.Press Enter/Pause. The current setting is displayed, for example:

Select Config

Def 2

3. Press or to see the other options. After you display the option you want, press Enter/Pause.

Are you sure?

No ￿

4.Select Yes or No. If you select “Yes,” the file is sent immediately to the verifier. This configuration is active for all formats until another verifier configuration packet is specified. See “Defining the Verifier Field” or “Defining the Verifier Configuration Packet” for more information.

5.Press Escape/Clear until you see the Main Menu.

5-4Operating Instructions