10. Insert the horizontal shaft (with two different diameters) into the mounting block as shown. Insert the set screws into the top of the mounting block. Align the flat on the shaft with the set screws in the mounting block.

For knife printers, the shaft should be flush with the left edge of the mounting block.

For non-knife printers, insert the shaft so the step in the shaft is flush with the right edge of the mounting block.

Knife Setup

Non-Knife Setup

Note: Securely tighten ALL the set screws in the shaft and mounting block with a 3/32 Hex key.

11. Look at the stand from above. Adjust the stand so the horizontal shaft is parallel (aligned) with the front edge of the base plate. Securely tighten the three screws attaching the stand to the base plate.

Installation & Setup 2-5