S e t t i n g U p t h e V e r i f i e r w i t h S c a n V i s i o n
Use RJS ScanVision software to set up verifier by taking a Scan Profile (Reflectance).
Installation of the verifier requires proper mounting position, port configuration(s), and LED configurations to ensure reliable and accurate operation.
1.Install the verifier at the proper distance and angle. See “Installing the Verifier” in Chapter 2 for more information.
2.Connect the cables. See “Connecting the Cables” in Chapter 2 for more information.
3.Run the ScanVision software.
4.Set the verifier for parallel bar code travel direction.
5.Place a sample bar code in the center of the intended laser beam path. For best results, this sample should match
the type of bar code(s) and material that is to be analyzed in the final application.
6.Knowing the X dimension (narrow element width) of the bar code(s) is a big plus. Refer to the Packet Reference Manual (on the Tabletops Documentation
I2of 5 bar code with 9.9 mil X dimension
For example, this I2of5 bar code has a density of 12 and an
Note: The Calibration label has a 10 mil X dimension unless otherwise indicated.
7.Take a Scan Profile (Reflectance) with ScanVision by clicking 
. Refer to the SV Series Operator’s Guide for more information:
a)The bar code(s) should be in the center of the scan path.
b)The scan profile should not contain distortions from light reflecting from objects in or near the light path. One major aspect in a good profile is the low reflectance points (the bars) in the symbol are uniform all the way across the code.