7.Attach the L-bracket to the base plate with two screws:

For knife printers, attach the L-bracket to the left side of the base plate.

For non-knife printers, attach the L-bracket to the center of the base plate.

Knife Setup

Non-Knife Setup

Note: Do not fully tighten these screws.

8.Insert the vertical shaft into the stand until it stops. (The vertical shaft has one diameter; the horizontal shaft has two different diameters.)

Insert the set screws into the stand. Align the flat on the shaft with the set screws in the stand.

Knife Setup

Non-Knife Setup

Note: Securely tighten the set screws with a 3/32 Hex key.

Installation & Setup 2-3