Paxar 938 .exe, setup.exe, Note: Do not

U n p a c k i n g t h e V e r i f i e r

After you unpack the verifier, you should have the following:

♦938 verifier

♦I/O cable

♦9-pin communications cable

♦base plate (with two shafts, stand, mounting block, L-bracket, and attaching parts)

♦calibration label

♦SV Series Operator’s Guide (You will need to refer to this manual).

Note: Do not lose the calibration label! You need it to configure the verifier.

Keep the box and packaging material in case the verifier ever needs repair.

B e f o r e I n s t a l l i n g t h e V e r i f i e r

♦You need a 3/32 Hex key (wrench) to install and tighten the verifier’s stand.

♦Install the ScanVision software. The ScanVision software is found on the Tabletops Documentation CD-ROM. Run the file, setup.exe and follow the prompts as necessary.

♦Install the Monarch Paxar Verifier Configuration Tool. This tool can be downloaded from our Web site. To install, run the .exe file and follow the prompts as necessary.

1-2Operating Instructions