2.Align the hole in the printer over the hole in the base plate.

Make sure the cables underneath the printer are flat and not in the way.

3.Attach the printer using the shoulder screw provided without the cork washer. Tighten securely. If the printer is not held down securely, then add the cork washer provided with the printer. Use your finger to tighten this screw.

May or may not need this cork washer.

4.Attach the L-bracket to the printer using the screw you removed. For knife printers, attach the L-bracket to the side of the printer. For non-knife printers, attach the L-bracket to the front of the printer where the printer’s base cover was attached.

Knife Setup

Non-Knife Setup

5.Align the printer if necessary and tighten the screws in the L-bracket.

Installation & Setup 2-9