For the remote control to communicate with the TV, both TV and remote control should be paired (linked) with each other. Once paired, you cannot use the remote control to control another TV.
When you started the initial TV installation, the TV invited you to press the OK key, and by doing so, the pairing was done. When you switch off the TV, the pairing is stored. You can pair up to 5 remote controls with this TV.
Pairing Again
You can pair another remote control with this TV.
The method to pair a remote control is different for a remote control already paired with another TV compared with a remote control that is not paired yet.
•The remote control is paired with another TV
To pair, hold the remote control close to the Philips logo (about 10cm) and press the Red and Blue key at the same time. A message will appear if pairing is successful.
•The remote control is not paired yet
To pair, hold the remote control close to the Philips logo (about 10cm) and press OK. A message will appear if pairing is successful.
Retail
To pair a new — not yet paired — TV with a remote control which is already paired with another TV, hold the remote control close to the Philips logo (about 10cm) and press
the Red and Blue key at the same time.
A message will appear if pairing was successful.
6.6
IR Sensor
The remote control of the TV uses RF (radio frequency) to send its commands to the TV. With RF, you do not need to point the remote control at the TV.
However, the TV can also receive commands from a remote control that uses IR (infrared) to send commands. If you use such a remote control, always make sure you point the remote control at the infrared sensor on the front of the TV.
6.7
Batteries
The TV will notify you when the battery power of the remote control is low.
To replace the batteries, open the battery compartment on the keyboard side of the remote control.
1 - Use a small coin or other small, blunt object and press the rectangular shaped release button to open the battery lid.
2 - Slide the blue lock open in the direction shown by the arrow and lift the lock.
3 - Replace the old batteries with 2 type
4 - Push the blue lock down and slide it back until it clicks.
5 - Reposition the battery door and push it down until it clicks.
Put the remote control down for about 15 seconds to calibrate the pointer.
Remove the batteries if you are not using the remote control for a long time.
Safely dispose of your old batteries according to the end of use directions.
For more information, press Keywords and look up End of use.
6.8
Cleaning
Your remote control is treated with a
To clean the remote control, use a soft damp cloth. Never use substances such as alcohol, chemicals or household cleaners on the remote control.
28
