!AutoTA and EQ changes the audio settings
asbelow:
Thefader/balance settings return to the
centerposition. (Refer to page 75.)
Theequalizer curve switchesto FLAT.
(Referto page 73.)
Itwill be adjusted automatically to high
passfilter setting for front,center and
rearspeaker.
!Ifyou carr y out auto TAand EQ when a pre-
vioussetting of this already exists, the set-
tingwill be replaced.
Carrying out auto TAand EQ1 Stopthe car in a place that is as quiet
aspossible, close all doors, windows and
thesun roof, and then turn the engine off.
Ifthe engine is left running, engine noise may
preventcorrect auto TA and EQ.
2 Fixthe supplied microphone in the cen-
terof the headrest of the drivers seat, fa-
cingforward, using the belt (sold
separately).
Theauto TA and EQ may differ depending on
whereyou place the microphone. If desired,
placethe microphone on the front passenger
seatto carry out auto TA and EQ.
3 Turnthe ignition switch to ON or ACC.
Ifthe car s air conditioner or heater is turned
on,turn it off. Noise from the fan in the air
conditioneror heater may prevent correct auto
TAand EQ.
#PressSOURCE to turn the source on if this
unitis turned off.
4 Selectthe position for the seat on
whichthe microphone is placed.
Referto Using the position selector on page
75.
#Ifno position is selected before you start auto
TAand EQ, FL is selected automatically.
5 PressSOURCE and hold until the unit
turnsoff.
6 Pressand hold EQ to enter the autoTA
andEQ measurement mode.
7 Plugthe microphone into the micro-
phoneinput jack on the hide-away unit.
8 TouchSTART to start the auto TAand
EQ.
9 Getout of the car and close the door
within10 seconds when the 10-second
count-downstarts.
Themeasurement tone (noise) is output from
thespeakers, and auto TA and EQ begins.
#Whenall speakers are connected, auto TA
andEQ is completed in about nine minutes.
#Tostop auto TA and EQ, touch STOP.
Audio Adjustments
En 81
Section
15
AudioAdjustments