MGC+50/MGC+100 Getting Started Guide
Table
Field | Description |
|
|
Clock | This column is valid only for ISDN and Serial |
| Network Interface cards. |
| On the |
| the Master and the Backup clocks can be set on any |
| of the spans connected to the module. |
| This column indicates which Network card/span is |
| used as the Master Clock and which one is used as |
| the Backup clock. |
|
|
Configured Clock | Indicates which ISDN Network card or MPI Span |
| was configured as the Primary network interface (for |
| clocking), and which one is used as backup. |
| Changes take effect and are updated during the next |
| MCU reset or power up. |
|
|
Status | Indicates the card status; Normal or Faulty. |
|
|
Occupied Units | Indicates the units on the card that are currently |
| used to run conferences. For example, 1, 6 indicates |
| that two units, unit # 1 and unit # 6 are used to run |
| conferences. |
|
|
Faulty Units | Indicates if there are units on the card which are |
| faulty and the sequential number of the faulty unit. |
|
|
Disabled Units | Indicates the units that were disabled by the |
| operator. |
|
|
Num Units | Indicates the total number of units available for each |
| module. |
|
|
For more information about viewing card parameters, see MGC Manager
