Assembling the AMT

23

8.On the opposite side of the center support from the handles of the screwdrivers, insert the four ⁵₁₆-inch x

3¹₂-inch hex head bolts. Attach a ⁵₁₆-inch nylon lock nut to each bolt. Partially tighten the fasteners, then remove the screwdrivers.

Figure 6: Lower side arm attachment

9.Adjust the side arm supports as needed, then tighten all of its fasteners to 160 inch-pounds of torque.

10.Extend the adjustable feet on the side arm supports until they touch the floor, then remove the spacer block from under the back end of the AMT.

Note: If necessary, use a ⁹₁₆-inch open-ended wrench to loosen the jam nuts on the adjustable feet.

Page 101
Image 101
Precor 303135-111 manual Lower side arm attachment