Precor 303135-111 manual Reposition the adjustable feet as needed

38 Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers

3. Reposition the adjustable feet as needed.

If you want to …	Then turn the adjustable feet …
Raise the front end of the AMT	Counterclockwise
Lower the front end of the AMT	Clockwise

Figure 22: Location of adjustable feet and jam nuts

Important: To allow the rear pedestal to fit properly, the adjustable feet must extend at least 2" (5 cm) below the side arm supports. Extending the feet before you remove the spacer block, as described in the section Adding the Side Arm Supports earlier in this chapter, ensures that they are positioned correctly.

4.When you are finished positioning the adjustable feet, place the unit on the floor. Try rocking it again, as described in step 1, to verify that it is level.

5.Using the ⁹₁₆-inch open-ended wrench, move the jam nuts upward until they contact the side arm supports. Tighten the jam nuts completely.

6.Align the rear pedestal over the back frame tube and the side arm covers, then press it gently into place.

Figure 23: Rear pedestal attachment