Precor 303135-111 manual Adding the sleeve and washer

Assembling the AMT 21

3.Slide one ⁵₁₆-inch flat washer and one ⁵₁₆-inch sleeve over one of the ⁵₁₆-inch x 3¹₂-inch hex head bolts.

Figure 3: Adding the sleeve and washer

4.Insert the ⁵₁₆-inch x 3¹₂-inch hex head bolt, with the washer and sleeve, into the screw hole on the inside of the right-hand side arm. Attach a ⁵₁₆-inch nylon lock nut to the end of the bolt and tighten partially.

Important: Be sure to insert the bolt into the inward side of the side arm and apply the nut to the outward side, as shown in the following figure. If the bolt is inserted in the other direction, the side arm covers will not fit. Do not tighten fasteners completely until instructed to do so.

Figure 4: Bolt and sleeve attachment to install side arm support

5.Repeat steps 1 through 4 to attach the left-hand side arm support to the left side arm.