Precor 303135-111 manual Adding the Side Arm Supports, To add the side arm supports

20 Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers

Adding the Side Arm Supports

In the next procedure you will need the following pieces of hardware:

Two side arm supports

Two inner side arm covers

Two outer side arm covers

Six #10 x 1¹₄-inch self-tapping screws

Six ⁵₁₆-inch x 3¹₂-inch hex head bolts

Six ⁵₁₆-inch nylon lock nuts

Six ⁵₁₆-inch flat washers

Four ⁵₁₆-inch x 1-inch hex head machine screws

Important: The side arm supports are shipped with foam blocks inserted in one end. These blocks are provided to prevent fasteners from falling into the supports. Do not remove the foam blocks or push them down into the supports.

To add the side arm supports:

1.Place the upper end of the right-hand support against the right-hand side arm.

2.Insert two ⁵₁₆-inch x 1-inch hex head machine screws (with washers attached) into the two holes underneath the side arm support bracket and tighten partially.

Figure 2: Machine screw attachment to install side arm support