Precor 303135-111 manual Lower side arm support alignment

22 Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers

6.Place the flanges of the two side arm supports against the sets of screw holes on the center support. Insert a screwdriver through the middle holes in both flanges and the center support to keep the screw holes aligned.

Note: Use narrow screwdrivers, such as #1 Phillips screwdrivers, for this step. If necessary, use them to help pull the side arm supports into place against the center support.

Figure 5: Lower side arm support alignment

7.Slide a ⁵₁₆-inch flat washer over each of the four ⁵₁₆-inch x 3¹₂-inch hex head bolts.