Precor 303135-111 manual Required Tools, Unpacking the AMT, To unpack the AMT

Assembling the AMT 19

Required Tools

#2 Phillips screwdriver

Rubber mallet

SAE standard socket set

Wire cutter

Two #1 Phillips screwdrivers

Torque wrench (calibrated in inch-pounds, and including ³₁₆-inch hex wrench bit)

Unpacking the AMT

DANGER Do not attempt to connect electrical power until all assembly procedures are complete and the console is properly installed.

CAUTION: Do not climb onto the AMT until directed to do so.

Follow these steps to remove the AMT base unit from its shipping container.

To unpack the AMT:

1.Remove the rear pedestal and set it aside.

2.Remove and discard the fastener securing the back of the center support to the shipping pallet.

3.Remove and discard the bolts and nuts securing the wooden supports to the side arms of the AMT.

4.Remove the fasteners securing the wooden supports to the shipping pallet, then discard the supports and the fasteners.

Important: In the following step, do not force the foam block placed around the center support. Doing so may damage the plastic cover on the center support. Instead, slide the foam block backward until you have removed it from the plastic cover, then lift it out of the way.

5.Cut and remove the plastic ties, bubble wrap, and foam blocks securing the unmounted parts inside the shipping container.