Precor 303135-111 manual To move the AMT from the pallet to its intended location

Assembling the AMT 25

13. Repeat the previous two steps for the left side arm.

After the side arm supports are secured, move the AMT off of its shipping pallet to the location where you intend it to be used.

CAUTION: Do not move the AMT off of its shipping pallet without assistance. Do not apply any weight or other force to the side arms of the AMT until the side arm supports have been installed. To avoid unnecessary movement of the foot plates, do not position the handlebars until instructed to do so.

To move the AMT from the pallet to its intended location:

1.Remove and discard the two fasteners securing the front frame tube of the AMT to the shipping pallet, as shown in the following figure.

Figure 9: Front pallet anchor locations

2.Lift the back end of the center support and roll the AMT forward while your assistant stabilizes its front end and guides it off the shipping pallet onto the floor.

3.Move the AMT ahead to its intended location.

4.Insert the end caps into the front frame tube. If necessary, use a rubber mallet to tap them into place.