Precor 303135-111 manual Removal of screws from inner plastic molding

24 Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers

11.Remove the two #10 x ³⁄₄-inch Phillips-head screws securing the upper back corner of the inner plastic molding to the end of the right side arm.

Figure 7: Removal of screws from inner plastic molding

12.Fit the right-hand inner and outer side arm covers to the right side arm. Insert three #10 x 1¹₄-inch self-tapping screws and the two #10 x ³₄-inch screws you removed in the previous step, then tighten all of the screws completely using a #2 Phillips screwdriver.

Note: Tighten the screws to between 8 and 12 inch-pounds. Alternatively, tighten the screws until the two side arm covers are in full contact, then turn the screws an additional quarter turn.

Figure 8: Side arm cover attachment