Printronix L5035 user manual Copy /b filename.dwn LPT1 Return

Loading Flash Memory (If Equipped)

51.Download the files to the printer by using the DOS copy command. You can download the files one at a time by entering one file name per DOS copy command. Alternatively, you can copy multiple files in one copy command.

To download one file at a time, enter the following at the DOS prompt, for example:

copy /b file_name.dwn LPT1 <Return>

To download multiple files, enter the following at the DOS prompt, for example:

copy /b file_name1.dwn+file_name2.dwn+... LPT1

<Return>

NOTE: The above command examples assume that LPT1 is used as the download port from the computer, and that the printer is already in download mode, waiting for file download, before you copy the files to the printer. If you are downloading the files using the LPT2 port on the computer, substitute “LPT2” for “LPT1” in the above commands.

52.While the files are being copied into memory, the printer LCD informs you of the load process and status. (Messages are listed in the table following this section.)

53.Wait until the new files have successfully loaded into printer memory.

54.If you have any more software to install (logo, form, TIFF, setup, or font files), go back to step 43.

55.When all of the new software has successfully loaded into memory and the printer has reset itself, set the printer power switch to O (off).

56.Remove the diskette(s) from the computer and store them with the printer.

57.If you had to install a parallel data cable to the computer and printer in step 11, continue with step 58. If not, skip to step 64.

58.Unplug the printer AC power plug from its electrical outlet.

59.Power off the computer.

119