Printronix L5035 user manual Paper Selection, Cut Sheet Output, Fanfold Output

Paper Control Menu

For example, a form length parameter setting of 10 inches results in a paper length setting of 10 inches, as 10 inches is within the valid range for form length and paper length parameters. A form length setting of 24 inches results in a paper length setting of 12 inches, as 24 is above the valid range. A form length setting of five inches results in a paper length setting of 10 inches, as five is below the valid range.

•Inch Select/Length in Inches. This allows you to set the paper length in inches. The range is 7.0 to 20.0 inches, in one-half inch increments. The default is 11.0 inches.

•6 LPI Select/Length at 6LPI. This menu selection allows you to set the paper length in lines. The range is from 42 to 120 lines, in 1 line increments. The default is 66 lines.

Paper Selection

Paper selection specifies the type of paper and, for the cut sheet option, the cassette to be used. You may select fanfold (factory default) paper, or the upper or lower cassette, which holds various sizes of cut sheet paper.

Cut Sheet Output

Cut Sheet Output specifies which output tray is used. You may select the face down (default) or face up orientation. The face down tray is located on the top of the printer, the face up tray is located above the optional power stacker.

NOTE: If you select the face up tray, the first page printed is on the bottom of the stack, and the last page printed is on the top of the stack.

The Cut Sheet Output menu option is used only if the printer has the cut sheet paper feed option installed.

Fanfold Output

The Fanfold Output option specifies the paper path through the stacker. You can select either into the stacker (default) or to bypass the stacker.

71