
Printer Functions
Stacker Operation Keys
The power paper stacker contains the following keys for operating the elevator:
•AUTO: Sets the elevator in automatic mode. Pressing this key causes the elevator table to rise until it reaches its maximum upper position and enables the stacker.
•STOP: Stops the elevator, and displays the message “STACKER NOT READY” on the printer control panel. The STOP key may be used to stop the elevator from lowering after pressing the DOWN key.
•DOWN: Lowers the elevator until it reaches its maximum lower position, or until the STOP key is pressed.
•HEAVY: ON equals “Heavy Mode” for thicker paper (LED is lit); OFF equals “Normal Mode” for thinner paper (LED is not lit). This key is only active in STOP mode and when there is no paper in the stacker.
When operating the power stacker in Heavy Mode, the maximum stack height following a cut or page eject depends on the page length, as shown in the following table:
Page Length (inches) | Max. Stack Height (inches) |
|
|
7.0 | 7.5 |
|
|
7.5 | 7.2 |
|
|
8.0 | 7.0 |
|
|
8.5 | 6.6 |
|
|
9.0 | 6.4 |
|
|
9.5 | 6.1 |
|
|
10.0 | 5.8 |
|
|
10.5 | 5.5 |
|
|
41