Printer Functions

Removing Paper

1.Upon completion of a print job, press the PAGE EJECT key on the printer control panel, and separate the paper at the perforation.

2.Press the DOWN key on the stacker to lower the elevator (stacking table).

3.Press the STOP key on the stacker when the elevator is about half-way down.

NOTE: The elevator stops automatically when it is fully loaded, without the STOP key being pressed.

4.Remove all paper (the completed print job) from the elevator, and do one of the following:

To change the paper mode, go to Step 5

To reload paper after a paper path error, go to Step 6

To resume operation, go to Step 7

5.If necessary, you may change the paper mode at this point, by pressing the HEAVY key. ON equals “Heavy Mode” for thicker paper (LED is lit); OFF equals “Normal Mode” for thinner paper (LED is not lit). This key is only active in STOP mode and when there is no paper in the stacker.

6.If the printer reports an error which requires the paper path to be cleared, be sure to reload the paper with the first perforation facing inward (see the illustration on page 29). Then press the CLEAR key on the control panel. Otherwise, the paper may jam and/or fold incorrectly.

7.Press the AUTO key on the stacker to automatically resume operation.

CAUTION Always remove all paper from the elevator before pressing the AUTO key on the stacker. Failure to remove all paper may damage the stacker.

43

Page 43
Image 43
Printronix L5535 manual Removing Paper