GBIC

GBIC

GBICs may be removed and replaced with the Switch power on without disrupting traffic on other ports.

Removal

1.Disconnect the cable (if one is connected) from the GBIC you are removing.

2.Remove GBICs. Some GBICs have individual latches; others are operated by

abuilt-in bail. To remove GBICs that have individually operated latches, as shown in Figure 4-3, do the following:

a.Using the thumb and forefinger of one hand, grasp the GBIC and press both latches toward the center of the GBIC.

b.While squeezing, withdraw the GBIC from the chassis. When the GBIC is withdrawn, a spring-loaded door will close the port opening.

NOTE:

The force required to overcome the friction of the pins in the GBIC connector and withdraw it from the chassis may be more than you can exert without your fingers slipping off the latches. If you have trouble, try a piece of double-backed tape under your thumb and forefinger to get a better grip on the GBIC. Do not use pliers or similar tools. You may damage the GBIC.

GBIC

Latch

Figure 4-3 Removing GBICs that have individually operated latches

SANbox-16HA Fibre Channel Switch

 

Removal/Replacement Procedures 4-3

Installer’s/User’s Manual

59005-03 Rev. A

Page 79
Image 79
Q-Logic 16HA user manual Gbic