Q-Logic 5000 manual Configuration File System Error Blink Pattern

A

5 – Diagnostics/Troubleshooting Power-On Self Test Diagnostics

5.2.1.3

Configuration File System Error Blink Pattern

A configuration file system error blink pattern is 4 blinks followed by a two second pause. The 4-blink error pattern indicates that a configuration file system error has occurred, and that the configuration file must be restored.

2 seconds

To restore the switch configuration, do the following:

1.Establish communications with the switch using Telnet. Enter one of the following on the command line:

telnet xxx.xxx.xxx.xxx or

telnet switchname

where xxx.xxx.xxx.xxx is the switch IP address and switchname is the switch name associated with the IP address.

2.A Telnet window opens prompting you for a login. Enter an account name and password. The default account name and password are (admin, password).

3.Open an admin session to acquire the necessary authority.

SANbox $>admin start

4.Restore the configuration. When the restore is complete, the switch will reset.

SANbox (admin) $>config restore

If a configuration does not exist, enter the Config Backup command, then enter the Config Restore command.

59096-04 A 5-5