Ricoh 350e, 450e

USA (This information is for facsimile option users only.)

❖

FCC Requirements

1. This equipment complies with Part 68 of the FCC rules. On the cover of this equipment is a label

that contains, among other information, the FCC registration number and ringer equivalence

number (REN) for this equipment. If requested, this information must be provided to the tele-

phone company.

2. This equipment uses the following USOC jack: RJ11C

3. The REN is used to determine the quantity of devices which may be connected to the tele phone

line. Excessive REN's on the telephone line may result in t he dev ices not ring ing in respon se to

an incoming call. In most, but not all areas, the sum of the REN's should not exceed five (5.0).

Contact the telephone company to determine the maximum REN for the calling area.

4. If this equipment causes harm to the telephone network, the telephone company will notify you

in advance that temporary discontinuance of service may be required. If advance notice is not

practical, the telephone company will notify the cu sto me r as s oon as p os sib le. Also, you will be

advised of your right to file a complaint with the FCC if you believe it is necessary.

5. The telephone company may make changes in its facilities, equipment, operations, or proce-

dures that could affect the operation of the equipment. If this happens, the telephone company

will provide advance notice in order for you to make necessary mod ifications in ord er to maintain

uninterrupted service.

6. In the event of operation problems (document jam, copy jam, communication error indication),

refer to the solving problems section in this manual.

7. If you cannot correct the problem, please contact the RICOH CORP. CUSTOMER SUPPORT

DEPT. at 1-800-FASTFIX for repair and warranty information. If it is causing harm to the tele-

phone network, the telephone company may requ es t you to disconnect the equipment from the

network until the problem is resolved.

8. This equipment cannot be used on telephone company-provided coin service. Connection to

Party Line Service is subject to state tariffs.

❖

WHEN PROGRAMMING EMERGENCY NUMBERS AND/OR MAKING TEST CALLS TO

EMERGENCY NUMBERS:

1. Remain on the line and briefly explain to the dispatcher the reason for the call before hanging

up.

2. Perform such activities in the off-peak hours, such as early morning hours or late evenings.

CANADA (This information is for facsimile option users only.)

The Industry Canada label identifies certified equipment. This certification means that the equipment

meets telecommunications network protective, operational, and safety requirements as prescribed in

the appropriate Terminal Equipment Te chnica l Requ ir emen ts docu men t(s) . The de part ment do es no t

guarantee the equipment will operate to the user's satisfaction.

Before installing this equipment, users should ensure that it is permissible to be c onnec ted to the fac il-

ities of the local telecommunica tions company. The equipment must also be installed using an accep t-

able method of connection. The customer should be aware that compliance with the above conditions

may not prevent degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative designated by the supplier.

Any repairs or alterations made by the user to this equipment, or equipment malfu nctions, may give the

telecommunications company cause to request the user disconnect the equipment.

Users should ensure for their own protection that the electrical ground con necti ons of the po wer utilit y,

telephone lines, and internal metallic water pipe system, if present, are connected together. This pre-

caution may be particularly important in rural areas.

Caution: Users should not attempt to make such connections themselves, but should contact the ap-

propriate electric inspection authority, or electrician, as appropriate.

The Ringer Equivalence Number (REN) assigned to each termina l devi ce provid es an i ndica tio n of the

maximum number of terminals allowed to be connected to a telephone interface. The termination on

an interface may consist of any combination of devices subject only to the requirement tha t the sum of

the Ringer Equivalence Numbers of all the devices does not exceed 5.

In accordance with IEC 60417, this machine uses the following symbols for the main power switch:

a means POWER ON.

c means STAND BY.