
PARTIAL COPYING
The Partial Copy function copies only a part of an original.
You need to enter start and end points in the original feed direction.
| a |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| Synchro Cut Mode |
| |
| b |
| ||||
|
|
|
|
|
|
|
original |
|
|
|
|
| Bypass Table |
|
|
|
|
|
| Preset/Variable Cut Mode |
Notes
❐You cannot use the Partial Copying function using the Rear Table.
❐You cannot use the Partial Copying function for originals shorter than 255 mm.
❐If you set the start point within 155 mm from the leading edge of the original, the copier will regard the leading edge as the start point.
❐The minimum available space between the start point and the end point is 30 mm.
❐If you do not set the end point after setting the start point, the copier will regard the trailing edge of the original as the end point.
❐If you set the start point within 40 mm from the trailing edge of the original, the copier will cancel the copying and exit the original.
❐If you set the end point within 40 mm from the trailing edge of the original, the copier will regard the trailing edge as the end point.
❐In the Synchro Cutting function, the copier will cut the paper in a length from the start point to the end point.
❐When selecting the Partial Copying function, the copier will reset the settings for the trailing edge margin, the leading edge margin in the Synchro Cutting function, and the Repeated Copying function.
1Hold down the Function Select key for three seconds.
A “P” will blink in the copy counter display.
Paper Length |
| Cut Select | ||
Synchro |
|
| ||
Preset/ |
|
| ||
Variable |
| Preset Cut | ||
|
|
|
| |
Leading Edge |
|
| ||
Trailing Edge |
|
| ||
Copy Counter |
| Bypass Select/ | ||
|
|
|
| |
Function Select |
| Roll Paper Cut | ||
|
|
|
|
|
31