PARTIAL COPYING
The Partial Copy function copies only a part of an original.
You need to enter start and end points in the original feed direction.
a
Semi Synchro Cut Mode
b
Original | Copy Paper Table |
| Preset/Variable Cut Mode |
Notes
❐You cannot use the Partial Copying function using the Rear Table.
❐You cannot use the Partial Copying function for originals shorter than 150mm.
❐You can use the Partial Copying function for originals longer than 1270mm.
❐If you set the start point within 130 mm from the leading edge of the original, the copier will regard the leading edge as the start point.
❐The minimum available space between the start point and the end point is 30 mm.
❐If you do not set the end point after setting the start point, the copier will regard the trailing edge of the original as the end point.
❐In the Semi Synchro Cutting function, the paper extend by 140mm from the end point. if you do not set the end point, the paper extend by 270mm as the trailing margin.
1Hold down the Function Select key for three seconds.
A “P” will blink in the copy counter display.
Paper Length |
| Cut Select | ||
Semi Synchro |
|
| ||
Preset/ |
|
| ||
Variable |
| Preset Cut | ||
|
|
|
| |
Leading Edge |
|
| ||
Copy Counter |
|
| ||
Function Select |
| RF Select/Cut | ||
|
|
|
|
|
32
