Ricoh Aficio AP2700 Ing Paper and Other Media, Paper. ⇒ P.36 Paper Recommendations

	Other Printing Problems
Status	Possible Causes, Descriptions, and Solutions
Paper misfeeds occur fre-	Check the paper size settings. The size specified with
quently.	the paper size dial might be different from the actual
	paper size. Make the correct dial setting. ⇒ P.41 “Load-
	ing Paper and Other Media”
	Use the recommended paper. Avoid using curled,
	folded, or wrinkled paper, perforated paper, or glossy
	paper. ⇒ P.36 “Paper Recommendations”
	Confirm that the side guides and the rear guide of the
	paper tray are set in place. ⇒ P.41 “Loading Paper and
	Other Media”
	Clean the friction pad and the paper feed roller, if it is
	dirty. ⇒ P.85 “Cleaning the Friction Pad” ⇒ P.83 “Clean-
	ing the Paper Feed Roller”
The operation panel error	Open the front cover of your printer and then close it.
message stays on after re-	Be sure to close the lower vertical paper feed cover. ⇒
		5
moving the misfed paper.	P.69 “Removing Misfed Paper”
Desired tray isn't used for the	Check the paper size settings. The size specified with
output.	the paper size dial might be different from the actual
	paper size. Make the correct dial setting. ⇒ P.41 “Load-
	ing Paper and Other Media”
	When you are using a Windows operating system, the
	printer driver settings overrides those specified using
	the operation panel. Specify the desired output tray us-
	ing the printer driver. See the driver's online help file.
The printed image is differ-	When you use some features such as enlargement and
ent from the image in the	reduction, the layout of the image might be different
computer.	from that shown in the computer display. Before print-
	ing, use the print preview to see how the page will look
	when printed. If necessary, adjust the settings.
It takes too much time to re-	The data is so large or complex that it takes time to pro-
sume printing.	cess it. If the Data In indicator is blinking, the data pro-
	cessing is being done. Just wait until it resumes.
	Energy Saver mode might be enabled. In Energy Saver
	mode, it takes time for the machine to warm up. ⇒ P.89
	“Using the Operation Panel”
Image is printed in the	Specify the correct orientation under the “PCL Menu”
wrong orientation.	with the operation panel. ⇒ P.89 “Using the Operation
	Panel”

67