Ricoh Aficio AP2700 operating instructions OHP Transparencies, Adhesive Labels, Envelopes

Paper and Other Media Supported by Your Printer

❖OHP Transparencies

•If you load OHP transparencies onto Bypass Tray Type 270, set the printer to "Transparency" mode using the printer driver.

•Be careful not to touch the print side of the OHP transparencies. Other- wise, the print side can become dirty or damaged, resulting in poor print quality.

•If you print on an OHP transparency that has a print side, load it face up onto tray 2 or load it face down onto Bypass Tray Type 270.

•Do not print on OHP transparencies for color.

❖Adhesive Labels

•Load only one adhesive label at a time onto Bypass Tray Type 270.

• Use adhesive labels in which the whole side can be printed on.
	4
• Avoid using adhesive labels having exposed glue.
• If the print side is coated, the print quality might be reduced, as the toner
might not fuse well.
❖ Envelopes
• When printing on envelopes, use tray 2 or Bypass Tray Type 270.
• You can specify the sizes for the envelopes using the operation panel.
⇒ P.94 “Job Control Parameters”
• Recommended of envelopes is as follows:
• Com#10 Env
• C6 Env
• C5 Env
• DL Env
• Monarch Env
• Do not stack envelopes over the limit mark.
• Confirm that print side is facing up when loading onto the tray 2.
• Confirm that print side is facing down when loading onto Bypass Tray
Type 270.
• Load the envelopes with the flaps aligned to the right side fence. The flaps
should be securely folded down.
• Confirm that there is no air in the envelopes before loading.
• To get better print quality, it is recommended that you set the right, left,
top, and bottom print margins, to at least 15mm (0.6") each.
• Do not print on both sides of envelopes.
• Load only one size and type of envelope at a time.
• Before loading envelopes, flatten the leading edges (side being fed into the
printer) of them by running a pencil or ruler across them.

37