
Printer Hard Disk Type 3000
17
1
EEE
EInsert the Printer Hard Disk by
aligning it with the controller
board slot, sliding it in the direc-
tion of the arrow, and then con-
necting it to the connector on the
controller board.
FFF
FFasten the Printer Hard Disk us-
ing the supplied screw.
GGG
GAlign the controller board t o the
top and bottom rails, and then
push in slowly until it stops.
Note
❒When installing other options
on the controller board, do not
close the controller board, but
go to the steps for installing the
option.
Important
❒The printer may not work prop-
erly if the controller board is not
set properly.
HHH
HFasten the controller board to the
printer with the two screws that
you removed in step C
CC
C.
When the power is turned on, the
Printer Hard Disk will be format-
ted automatically.
Note
❒After finishing installation, you
can check whether the Printer
Hard Disk is installed properly.
Print the configuration page
from the "List/Test Print"
menu. If it is installed properly,
you will see "Printer Hard Disk
Drive" for "Controller Option".
❒If the Printer Hard Disk is not
installed properly, reinstall it
from step B. If you cannot in-
stall it properly even after at-
tempting reinstallation, contact
your sales or service representa-
tive.
ZHBP170E
ZHBP180E
ZHBP070E
ZHBP010E
AresPGBOptionSetup-F_FM.book Page 17 Monday, July 29, 2002 1:12 PM